The Monster - Ram Intake, part number 42790, is a game - changer for your 2007.5 - 2018 Dodge Ram 2500/3500 with a 6.7L Cummins 1st/2nd Gen engine. This intake not only safeguards your RAM from costly grid heater bolt failure but also significantly boosts airflow. It increases the airflow to 1008CFM (77.01 lbs/min), a 133% improvement over the stock 432CFM (33.00 lbs/min). As a result, it raises the boost without increasing back pressure at the turbine, making your engine more responsive, powerful, and efficient. The Monster - Ram comes with 4 1/8' NPT ports for flexibility, allowing proper atomization in the air mass center while preventing wall wetting. It fits stock mounting points including sensors, wire harness, and dipstick tube. You have the option of a natural finish or a red powder - coat finish. Installation takes just 2 hours. Note that it's for pure race use only, requires emissions removal and a special ECM program, won't work with the stock boost tube, and the grid heater must be deleted. You'll need a Banks Boost Tube Upgrade or a custom boost tube as well.

How to use: Install the Monster - Ram Intake in your 2007.5 - 2018 Dodge Ram 2500/3500 with a 6.7L Cummins 1st/2nd Gen engine. It should take about 2 hours to install. Make sure to remove the emissions equipment and use a special ECM program as this is for race use only. Also, delete the grid heater to avoid bolt failure. You'll need a Banks Boost Tube Upgrade or a custom boost tube. Once installed, enjoy improved engine performance. Things to note: This product won't work with the stock boost tube. It's strictly for race use, so don't use it on regular roads. You must remove the emissions equipment and use a specific ECM program. Maintenance advice: Periodically check the 4 1/8' NPT ports for any blockages. Inspect the mounting points and sensors to ensure they're secure. If you notice any decrease in performance, check the intake for any signs of damage or debris.