Upgrade your 2016 - 2020 Honda Civic with Skunk2's Hard Anodized Rear Camber Kit. This kit is built on over a decade of adjustable camber technology used in race cars. Its new telescoping, opposing - thread design lets you adjust camber without disconnecting the arm from the chassis. Just loosen the jam nuts and twist for quick positive or negative camber adjustments. It's a must - have for enthusiasts looking to fine - tune suspension or correct negative camber from lowered ride heights. Adjust both positive and negative camber to reduce abnormal tire wear and boost handling and stability. Constructed from forged alloy steel, aircraft - quality 7075 aluminum, and plated for corrosion resistance. Comes with Skunk2's industry - leading, low - deflection polyurethane bushings and spherical bearings that improve OEM suspension geometry. Fits multiple 2016 - 2020 Honda Civic submodels including EX, EX - L, LX, and more.

Using the Skunk2 Rear Camber Kit is easy. First, locate the arm on your 2016 - 2020 Honda Civic where the kit will be installed. Loosen the jam nuts on the kit. Then, twist the appropriate parts to make positive or negative camber adjustments as needed. You don't have to disconnect the arm from the chassis, which saves you time. When you're done adjusting, make sure to tighten the jam nuts properly. As for maintenance, keep an eye on the corrosion - resistant plating. If you notice any signs of wear or damage, clean the kit with a mild soap and water solution. Also, check the polyurethane bushings and spherical bearings regularly for any signs of wear. If they seem to be in bad condition, it might be time to replace them. Always follow your vehicle's manufacturer guidelines when making adjustments to your suspension.