These Morimoto HD load resistors (Part Number: H275) are a must - have for automotive lighting. They're designed to fit various CANBUS systems including LED HyperFlash, EURO CANBUS, OTHER CANBUS, and 15+ MOPAR CANBUS. Using a cheap automotive load resistor is not only careless but dangerous as they can get extremely hot. These resistors must be mounted to a metal surface with screws. They come in a variety of configurations to meet all automotive lighting needs, whether it's a single resistor for an LED flasher or to bypass a basic canbus system, a dual resistor for positive and ground circuits, or the special 2015+ Mopar - Spec units. Features include integrated mounting points, an extruded aluminum housing, and 4 - gauge wiring exiting through ceramic ports to prevent contact with heated surfaces. With a wattage of 40W, a resistance of 7.5 ohms, a 9006 Male input, and a nickel - plated ring terminal output, these resistors are top - notch. The wiring is 14ga high - temp, and the shell is made of extruded aluminum with an anodized/laser - engraved finish. What's included? One Morimoto HD Load Resistor (various configs), an install card with installation reminders, and a 2 - year warranty.

How to use: First, make sure to choose the right configuration of the Morimoto HD load resistor according to your automotive lighting needs. Then, mount the resistor to a metal surface using screws. Connect the 9006 Male input and the nickel - plated ring terminal output as required. Be careful when handling the resistor as it can get hot during use. Note: Do not use a cheaply - made resistor as it can be dangerous. Always follow the installation instructions on the install card. Maintenance: There's not much maintenance required. Just check the wiring periodically to ensure there's no damage. Keep the resistor clean and dry. If you have any problems, you can rely on the 2 - year warranty.