This Main Stud Kit is a perfect fit for 1998.5 - 2003 Dodge vehicles with 24V 5.9L Cummins engines. Main cap bolts are vital for keeping the crankshaft aligned and ensuring proper seals at the main bearing caps. Stock bolts often fail under stress, leading to engine failure. The PPE Main Stud Kit solves this problem. Upgrade your Powerstroke engine with this high - quality chrome - moly alloy kit. These studs have a yield strength over 215,000 psi and a tensile strength over 230,000 psi. They are heat - treated, centerless ground, and thread - rolled to reduce stress and boost fatigue resistance. EDM technology is used for precision broaching. Both studs and nuts have a black oxide finish. The kit comes with an assembly lubricant packet for even load distribution and accurate torque readings. Part Number: 218035200. Features include high - performance chrome - moly alloy, verified 230,000+ psi tensile strength, secure main caps in stock or modified applications, prevention of main cap - induced engine damage and noise, maintenance of proper crankshaft alignment, and a black oxide finish. For installation, click here.

Using this main stud kit is straightforward. First, make sure your engine is turned off and cooled down. Remove the old main cap bolts carefully. Then, take the studs from the kit and install them one by one. Apply the assembly lubricant from the packet evenly on the studs and nuts. This will help in getting an accurate torque reading and uniform load distribution. Tighten the nuts according to the recommended torque settings. When it comes to maintenance, regularly check the studs and nuts for any signs of looseness or damage. If you notice any issues, replace them immediately. Also, keep the kit in a dry and clean place when not in use to prevent rust and corrosion.