Upgrade your engine's performance with this K&N Aircharger intake. Its high - density polyethylene (HDPE) rotationally - molded tube boosts airflow, guaranteeing more horsepower and torque. Paired with a washable, reusable High - Flow Air Filter using oiled cotton media, this oversized, conical filter can go up to 100,000 miles between services under normal highway driving. A custom heat shield protects intake air from engine bay heat. Installation usually takes less than 60 minutes. Note that some intakes aren't legal for pollution - controlled vehicles in California. Check product specs for CARB status. This part fits 2015 - 2016 Mitsubishi Lancer ES, GT, SE, 2016 SEL, and 2015 Evolution Final Edition, GSR, MR, and Ralliart models.

Using this K&N Aircharger intake is straightforward. First, make sure your engine is cool. Then, you can install the entire system in less than an hour following the included instructions. When driving, under normal highway conditions, you won't need to service the filter for up to 100,000 miles. But if you drive in dusty or dirty areas, you might need to check it more often. To clean the filter, use a K&N filter cleaning kit as described in the instructions. Always keep in mind that some parts of this intake might not be legal for use on pollution - controlled vehicles in California, so check the CARB status before installing it on your car.