Save 15% when you buy this high - quality pad and rotor kit instead of separate parts. It includes pads, rotors for both front and rear axles, and caliper lube. The high - efficiency Ultimax EBC pads are made with Aramid fiber, fully shimmed and chamfered. They have a patented EBC Brake - in coating for quick brake - in after installation. The rotors are direct OEM replacements with a geomet anti - rust surface coating. They are fully balanced and runout - tested for smooth braking. Remember, balanced and maximum braking happens when all brakes work. Rear brakes can contribute up to 40% of your vehicle's stopping power. Renewing front and rear brakes at the same time is a smart choice. This kit fits various 2008 - 2013 Subaru models including Impreza and Outback.

Using this EBC S20 Ultimax brake pad and RK rotor kit is straightforward. First, make sure your vehicle is parked on a flat surface and the engine is off. Then, remove the old pads and rotors carefully. Install the new rotors first, making sure they fit properly and are tightened to the correct torque. Next, put in the new pads with the caliper lube applied. It's important to note that after installation, you'll need to let the pads 'break - in'. This means driving normally but avoiding hard braking for the first few miles. For maintenance, regularly check the brake pads for wear. If they are getting thin, it's time to replace them. Also, keep an eye on the rotors for any signs of rust or damage. If you notice any unusual noises or reduced braking performance, have your brakes inspected right away.